Dassault Aviation is back in the FAA's crosshairs, a week after the agency proposed an airworthiness directive (AD) covering the main landing gear of Falcon 50, 2000 and 2000EX models. A manufacturing quality escape may have left high-temperature oxidation in the gear's upper and lower torque links, and the FAA estimates up to 178 of the 683 U.S.-registered airplanes have an affected part. Replacing a gear could cost up to $300,000 in parts, while rebuilding it with new torque link assemblies would run $48,990. Comments are due Dec. 28. The new issue is a follow-up to AD 2024-14-09, which requires replacement of certain titanium screws and adds other locations for screw replacement on certain Falcon 7X, 900EX and 2000EX aircraft. The FAA now says affected parts have been found on other 7X jets and in other areas. The proposal, published Nov. 19, expands the group of aircraft subject to corrective action and, by adopting EASA AD 2025-0228R1, drops calendar-based deadlines for parts replacement in favor of flight cycles. It covers 52 U.S.-registered airplanes at up to $21,774 each and remains open for public comment through Jan. 4, 2027. The manufacturer says warranty may cover some or all of the cost under both proposals. Expanding the directive to include more airplanes and more replacement locations places greater emphasis on aircraft configuration, maintenance history and compliance tracking as the scope of the issue continues to develop. It also means maintenance departments must evaluate whether aircraft previously believed to be outside the affected population remain outside of it. The Falcon 2000EX is named in both proposals, so some owners may be working two compliance tracks at once. Why it matters As the FAA expands the population of affected aircraft and components, compliance becomes increasingly dependent on accurate maintenance records and installed-part verification. Operators that maintain detailed configuration records can more quickly determine whether an aircraft is affected when new information emerges. The landing gear proposal shows how specific that gets: a gear with an affected part counts as serviceable only if that part has fewer than 7,100 flight cycles since its first installation on an airplane, a count that follows the part and can differ from the airframe's total cycles. Browse current Dassault Falcon listings on GlobalAir.com.